🔧 Convenient and Efficient Derale 25708 Remote Filter Mount Kit for Enhanced Filtration Performance Review

This simple kit is perfect. The mount I received did not have an additional temp sensor tab as shown in the product photo, but I was able to easily drill and tap into the temp sensor on the side of the inlet. Ideal for removed ATF filter. Many people ask what filters fit this mount. Every filter I've looked for that has a 3/4-16 thread also had the correct o-ring diameter. In the end I chose the Motorcraft fL400S because of the smaller diameter and also because the engine oil matches our two…

This filter adapter works as advertised for my parts cleaner except for one major flaw. The thread size for the nipple/adapter that attaches this housing to the filter is 3/4-16 UNF. This is a very unusual size and it is VERY difficult to find suitable filters. I tried using FRAM Extra Guard PH8A but as it is an oil filter it stopped the degreaser flow completely after a few months. Ideally either a fuel filter or coolant should be used, but I have not been able to find a filter with a 3/4-16…

For installing an exchangeable transmission filter. I definitely feel better with a thinner filter than the pan filter, aka the stone screen. I plan to put a new filter in every oil change. If you are trying to get more miles from the filter I would recommend installing a pressure gauge AFTER the filter to check the restriction. When things get restrictive, you can smoke the gears pretty quickly. Another tip: pay attention to the filter you use. While FL1A will do, I'm not sure if it's the best

Before the price, that's how it works! The kits came with different size hose fittings than my truck so I went out and bought all the fittings and used injector clamps which provide a tighter seal than worm gear clamps. Make sure you use thread tape to prevent leaks. I used a Baldwin B2 filter as it came highly recommended and all in all I spent about $70. Hopefully this will clean up my transmission and allow me to drive less on the road. I installed it on top of the frame beam behind my skid…