🚗 Dewhel Silver Shift Knob Boot Retainer/Adapter - Manual Gear Shifter Lever 10X1.25 - Enhanced SEO Review

Great product! Fits my Mazda 3 07 perfectly. It's metal so depending on the weather it will be hot or cold. I'm glad I bought it! You don't have to buy another one.

Looks and feels good when it works but it doesn't fit my short travel derailleur, if they made a shorter one it might work but the actual hole for threading, the arm was too small for my car, hope this helps

This little one fits perfectly. Dramatically improves the look of your derailleur by hiding the stem. Be sure to order the correct size or thread pitch for the switch stem. I made a mistake at first but then I ordered this one and it worked perfectly. These are metal so expect them to be hot or cold depending on the weather.

Product looks good but not for everyone. Be prepared to drill the top hole if it doesn't fit the shifter shaft and you'll need an o-ring for the bottom one to fill the 1-2mm gap. Looks good, holds up well when a lock nut is on and really shines when polished before installation. All around a great looking collar. I would definitely buy this again.

It was too small to screw on my 2003 Acura CL Type S 6 speed so I had to tap it with an M10x1.5 thread (luckily it came in handy to me). After I did it fit perfectly and looked infinitely better than nothing (there was nothing in my shift knob to cover the top of the shift boot). It would be nice if it came with a zip but overall pretty good value for money.

This is actually just the final element of the lever if you have play between the boot and the grip. Mine filled the gap and made the shifter much nicer. The only problem is that the duster has to go in the groove, but I have some kind of plastic insert so I just left it under the adapter. It still looks great and works just like the original nut for tightening the shift knob.

Purchased so I can replace the shift knob on my 370z without the unsightly 'gap' between the knob and the factory trunk mount. This adapter is simply pushed onto the shift shaft and screwed on completely and smoothly. Fitting my non-original boot to this adapter also only took a few minutes (to ensure proper alignment) and a very strong strap secured the boot to the adapter. Very easy.

Exactly what I needed, fits perfectly. The only small problem I had, and not so much the adapter's fault, was that my boot did not fit on this lower part, it was too wide, so I had to take the boot off and remove the rubber element in my boot as a zip -up adapter. what works, it looks really good, just a process, so be aware that you may need to make some modifications if your loading port is too small, since the bottom of the adapter is very wide.