🔒 Dome Glass Galaxy S21 Ultra Screen Protector: Full HD Clear 3D Curved Edge Tempered Glass [Compatible with Ultrasonic Fingerprint] - Easy Semi-Automatic 4 Step Installation by Whitestone (Two Pack) Review

I have had many Samsung Galaxy series phones and all the screen protectors I have tried do not stick to the rounded edges. Whitestone Dome is the only screen protector that actually sticks to the curved edges. However, this is not optimal. While it's advertised to work with an under-display fingerprint sensor, I've found that it doesn't. I increased the screen sensitivity and registered my thumb twice. On average it takes 3 attempts to unlock the phone with the sensor. I'm very disappointed…

Realize up front that you are paying a fortune for a plastic thing you still don't understand how to use as the written instructions are terrible and videos are the only way to know how to use it bypasses The Whitestone USB light is a device you will probably never use and is not at all worth the extra money you are spending. You're paying for a molded, sticky foam for the back of your phone that any smart person would use as a case to protect their phone and completely prevent this nonsense…

I've been using Whitestone Dome for a long time. S10+, One Plus 7 Pro, S20 Ultra, regular S20 and now S21 Ultra. I've never had any issues with the fingerprint reader before. It's a shame because the improvements Samsung has made to the reader this year have been incredible. However, what Whitestone has done this year now has such a negative impact on scanning that the S21 Ultra is significantly worse and faster and more reliable than previous models. With previous models, I wouldn't have seen…

The glass does not look flat and after the installer put it on the phone the area closer to the selfie camera was significantly raised. As a result, the glue didn't spread completely and I had to remove the glass. I tried the second jar provided and made sure I put the right side down and it behaved the same way. I have ordered a replacement if this is indeed the setup. difficult, but even if it was my fault, it also speaks volumes about how difficult the installation is. Update: I watched…

For those just skimming, avoid this junk. This product costs 5-6 times more than other screen protectors and what do you get for it? A cheap plastic installation tool that only complicates the process once you finally figure out how to use it, a USB flashlight you'll never use again, and cheap screen protectors. Okay, now that you've finally installed the screen and cleared out that other junk in case you inevitably need to replace the screen, what's left for you? With the default settings, the

First, the fingerprint reader really struggles with this built-in glass. It still works but drastically increases the number of failed reads. So overall I think the compatibility claim is about 50% wrong. Installation was pretty easy after watching the video on the website. However, I am very disappointed with the fit of the display cover. It's about 1/8 inch shorter, leaving a gap at the bottom of the screen. For those who installed a dome on the Note 9, this setup was much better and more…

This is my final review of a product that might be great and might suit some but not me. The first thing you should do is insert the top red part of the jig and slide it under the bottom part of the wind-up spring mechanism until both parts of the jig align, then lock the blue latch onto the top red plastic jig. Then wind the spring until it stops spinning and this is probably the most important step because if you press on it the spring will most likely break. If it allows you to keep winding…