🚗 Dorman 695-179 Rear ABS Wheel Speed Sensor: A High-Performance Upgrade for Dodge / Jeep Models Review

I just installed them last week. I only had to replace one but I bought 2 to change at the same time. I had a sensor with me. Replacing the screw, but there was no other. A sensor was also faulty which caused my jeep to go into limp mode after the brakes locked. Put the old one back in and it works. I want to replace the sensor and the screw. The other works fine.

I was 300 miles from home when my ABS sensor on my JK started working. Nothing compares to jeep ABS jerking at every corner of the highway while driving! Luckily I got home and ordered them. Two days later I was back in business. Easy replacement with a screw and wire harness. I've been driving them for 4 months and 7000 miles and so far they have held and solved my problem.

I have a 2013 jeep jku and the ABS and stabilizer bar light came on. I went to the port and bought the motor and ABS code reader for 130.00. hooked it up to the obd2 port and the scanner showed a left rear wheel speed sensor or tone ring. I bought this sensor from Revain and received it in less than 2 days. Took 5 minutes to install, taxied about 50 feet, and the ABS and stabilizer lights went out. Great product!

No noticeable difference compared to the stock part I had to replace. Installation was easy and my ABS/TC bulbs were fixed as expected. If necessary, there are videos on Youtube. To avoid the dealer paying what they ask for that part and installation. If you're familiar with the toolbox, you can probably fix it yourself with this part and save yourself a significant amount of money. Otherwise, drive the jeep to a place nearby where you won't get robbed.

2015 Rubicon JK, 3" Lift, 35s. Anti-lock Braking System Module. Not knowing if he was left or right, I ordered two of these replacement sensors. I watched a YouTube video to clarify the installation. And get to work. First, I replaced the "rear right” (the old one in the photo above), and the ABS lamp, of course, didn't go out! So replaced the "left rear" and drove 15 feet down the driveway, the ABS lights went out. I drove for a long time, turned on the four-wheel drive and drove in the mud…

My 2015 Jeep Wrangler traction control and ABS light came on. I've had this happen to me a few times on cars over the years, so I knew it was probably the ABS wheel speed sensor. I have an OBD programmer to adapt my speedometer to the large tires I use on my jeep. Part of this tool reads the codes. It says "No Signal, Left Rear ABS Sensor" so it's easy to tell which one needs to be replaced. I watched a YouTube video to find out where it is. When I was hit by a jeep it took me about 10 minutes…

This part fixed my rear ABS warning light on a 2007 Jeep JK Wrangler. Parts Storage Fees. If you're a do-it-yourselfer, you can install the part faster than going to the professional would be. The tricky part of this type of repair is diagnostics: knowing that the problem is with a faulty wheel speed sensor and which wheel is faulty. The OBD scan code U1417 only showed an implausible left side speed and did not isolate a problem with the front/rear or even with the wheel speed sensor. As if the