🔧 Dorman 905-203 Rear Upper Suspension Control Arm Bushing: Top-Quality Upgrade for Jeep Models, Black Review

Regret to say this product is really bad because then I saved up for the install when I decided to make the parts, only took two months and it broke. They really suck. Don't buy this because you will lose your money.

Low quality originals have lasted 70,000 plus, due to my error, both replace if only one was bad, know the left side of the rubber is torn, the right is broken. Manufacturer Dorman claims a lifetime warranty, but? through the use of a hydraulic press and a properly oriented, multi-year Chrysler and Honda service representative, ASE certified automotive technician.

They fit my 2001 Jeep Grand Cherokee, installed (with correct alignment) late Feb 2016, out of service Oct 2016. Do not use them unless you plan to do the job twice. I learned the hard way trying to save a buck (posts on Jeepforum.com told me they would fail). Original Chrystler/Mopar bushings are the only upper control arm bushings that last more than a year. The same goes for the BTW engine mounts.

Works on my 2001 Jeep Grand Cherokee (should work 99-04). too much turning). Most likely your rear upper hub is defective. I say this bushing needs to be replaced. Its job is to hold the rear of your car to align the rear axle. When you're turning or just changing lanes, the hub holds everything together. It takes most of the load on the car's rear suspension.