Dorman 924-425 Radiator Bushing: Enhanced Cooling System Efficiency Simplified Review

I changed the radiator on a 1997 Infiniti i30 and the old bushings were worn out, these new bushings are tight and hold the radiator in place.

This Dorman part is perfect for 98 Maxima. Excellent non-original spare part at a reasonable price. Parts are made in China but look good.

My wife's Maxima 99 needed new radiator bushings. I bought this and installed it with no problems. I even took the time to clean and paint the mounts.

My 2002 Maxima requires a 10mm socket to loosen the screw and remove the bracket that holds the rubber bushing. There are two brackets that hold the heatsink in place and rubber grommets prevent the heatsink from moving.

02 maxima. 2 x 10 nuts on top of radiator. pull one out, remove the bracket, slide through and insert a new one. The same with the other side. The radiator is now firmly in place and I couldn't be happier. highly recommended for the price.

My old sockets were completely worn out, cracked and loose. You can't even tell they're made of rubber if they are. I disassembled them and just pushed these new ones in with a flat head screwdriver. Made all the difference in the under hood vibration. Several examples of using a photo

Perfect fit for 95-99 Maximas. As far as quality goes, only time will tell if it will be comparable or better than its original counterpart. Got these as a replacement for my OEMs after installing a Mishimoto cooler. Have some modifications been made to my existing mounts as the Mishimotos cover sits higher and the hood cannot close properly? This places the top of the heatsink at a slight angle to the core support. Overall, the rubber bushings themselves serve their purpose.

For Nissan. 10mm nut, 1 screw per side and 5 minutes. IMHO the mounts are very worn by 10 years. Heatsinks with plastic caps break around this time, and anything you can do to stabilize will give you more time. Autotransformation is difficult. Assuming 5-SPD and no transmission cooler. Hydraulic connection and clamps in good condition, it's not much more than 15 min. Be careful. The radiator pins will pop out of the bottom rubber mount if they don't fall into the hole and the radiator will…

I have an 18 year old car - Infiniti I35 2003. My radiator bushings were starting to become brittle over time that I didn't even notice. Then I saw that the round center hole was now oval. When I took it apart I saw that pieces of rubber had fallen off. My radiator moves slightly. Time to order new bushings. For less than five dollars, that's no problem. The Dorman bushings fit snugly and tightly on my radiator mount. I use a few sprays of lithium grease to guide the bushings into the mount…