🚗 Dorman 926-446 Front Driver Side B Pillar Molding: Chrysler/Dodge Models, Black - Essential Car Trim Component! Review

I posted this in response to asking if a screw was included, but I think it should be posted here as well: No screw, no instructions. Although it's pretty obvious just by looking at it. You need a second person to push in and down, pull up and center. You can look to the side to see how much more you need to do by looking at the pin for the screw hole. Do not press on the floor until the grub screw is aligned with the hole. The most important part of the whole process is to leave the adhesive…

I bought this used, my dealer wanted $150 for what is basically a plastic sticker. Since it's half the price I decided to give it a try. Still seems a bit pricey for what it is but this is definitely the right place to buy it. Installation was a little tricky until I figured out how it was supposed to work. Only remove the plastic strips AFTER you have installed the part and make sure the gasket is where it should be. Stickers peel off immediately. I made the mistake of tearing them off first…

I bought this part to replace one that broke off while driving on the freeway and flew away. If I had known the dealer would charge $93 for the replacement I would have stopped and tried to return it. After learning the price at the dealer, I decided to find the part myself. Luckily I found it on Revain for less than half the price. This part is for the front door on the driver's side. There is a screw on the inside of the door that the part is attached to. It is also attached with 2 pieces of…

Unfortunately I trusted the claims that this part is exactly the same as the OEM part. IT IS NOT. The texture is NOT the same or different just because it's new. It is also MUCH thicker than the original part as shown in my photo. Not to mention potential door alignment issues, the part itself is about twice the thickness of the stock part on my '17 Dodge Grand Caravan. You can also see a decent rough spot (maybe 1.5cm) on the edge (burr?) from the manufacturing process, which I could probably…