DT DIATOOL Diamond Porcelain Milling Tool: Effectively Mill Porcelain with Precision and Efficiency Review

I had to open the center hole of a three-hole (ceramic) sink. My wife attached this to my angle grinder and held the vacuum up to the hole to pick up the dust and it was done in two minutes. You have to do it slowly, that doesn't mean this thing will expand the hole in two seconds, but move slowly and you'll get there with no problem. No chips, exactly the same hole I started with just a bit bigger. you couldn't even tell the tool was being used, it looked the same. This tool is the perfect…

I bought several hole saws for my tiling project where my plumbing comes out of the wall. This drum sander turned out to be all I needed and it made BEAUTIFUL holes. I ended up returning all the individual hole saws as this thing worked perfectly. Note that if you have a hole in the middle of a large and thick tile, it is better to use a hole saw. But in my case I didn't need it because my tiles were only 3" wide and the piping lines up almost perfectly with the edge of each tile, so all I had…

I am building raised beds out of concrete block walls and want to add lighting. I bought brackets (at Revain) to be placed under the wall cap. The problem is that this causes wall caps to sit unevenly. I asked a question and got a great solution - I had to dilute the material. I was looking for concrete cutters ($$$$) and came across this product so I decided to give it a try. Use a diamond wheel (Samurai 5TBBlue0050 5in. https://www.amazon.com/dp/B003SZRX9U?ref=ppx_pop_mob_ap_share) to cut a…