🍞 Eiechip Mini Breadboard Kit: 170 Point Small Solderless Breadboard for Proto Shield (6 Colors, 6pcs) Review

They make great extension and jumper wires. I even use them for motherboard extenders (for resetting CMOS for example).

Maybe I'm a little silly but when I first ordered it I was a little annoyed because I thought , the wires only need to be in groups of 40. To my delight I found that each wire can be separated from the rest leaving you with 120 individual wires (maybe I should have known that from the start).

So far so good recently used discrete circuit for prototype. It's a lot easier than soldering etc, especially when changing component values to meet end goals.

They're about half the size of a typical breadboard. Suitable for beginner projects or compact designs. Three in a pack is fun for the whole family.

Compact and contacts easily attach to cables. Small enough to throw on any development board or shield without tinkering with it.

They are about half the length of what I would call a typical breadboard. Suitable for beginner projects or compact designs. Three in a pack is fun for the whole family.

Maybe I'm a bit stupid but when I first ordered them I was a bit annoyed because I thought the Wires should only be groups of 40 pieces. To my delight I found that each wire can be separated from the rest leaving you with 120 individual wires (maybe I should have known that from the start).

Great product for testing your circuits! Do not use for real robot. Resistors will fall out if misplaced. I think the rails need to be made better. My wire sometimes goes sideways. They also extend the rails, so there is a chance that two adjacent rails will touch. (causes a short circuit)