🏗️ Ekena Millwork MIC03X03BI Inside Corner for Moulding Profiles 3 1/8" P x 3 7/8" H - White, 3 1/8"P x 3 1/8"W x 7 3/4"H Review

Easy as pie, just pre-install to make sure they match the corners, stick and stick on the corner. I used tape to give extra support while they dried so I didn't have to hold them down.

This corner block was exactly what I was looking for. The foam material allows me to fit the corners over the existing crown molding by tracing the profile on the blocks and then sawing them with a fretsaw.

I didn't know it was some kind of heavy foam. However, it took paint well and I was forced to use a finishing nailer to install it. Made the crown mound more beautiful and easier to install.

They were perfect for our new tiny bathroom we decorated in the master bedroom. They added just the right amount of pops to the crown bar we were looking for. it was easy to install and paint. Thank you for making this product. We plan to order it and use it again.

I used these to save some corner cuts in the corners of a sloping bedroom. I cut a 10 degree angle at the top of 6 of them and they all came out great. The cut is very clean, no chips or chips. A bit of spray paint to match the crown molding made the room look even more stylish and saved me the trouble of cutting the molding into two angles myself. I'll probably get more for the next room that gets a lick of paint.

First off these parts are beautiful when installed correctly and very economical for that vintage look. Far from being a contractor I'm done, I was looking for corner boxes because beveling 45 degrees was beyond my skills in any acceptable way. So these parts are a kind of molded resin. I eventually found that the best way to install them was to pre-drill holes in the corners that were hidden by the adjacent molding, with the holes facing the corner of the ceiling. Then I drilled a hole and the