🔌 66ft/20M 20 Gauge 2Pin Extension Wire, EvZ 20AWG 2 Conductor Parallel Electric Cable Cord for Single Color LED Strips 3528 5050, Red and Black Review

Misleading product. Based on our wire size chart, this wire ranges from 24 ga to 26 ga. You pay. In addition, the wire is made of aluminum. No copper wire or copper coated wire. Also, they intentionally removed ALL cable jackets from the printed board. This needs to be shown to ensure we know the limitations of this wire.

This wire works well and is as advertised. It shoots well and seems to fit 20 gauge. This is high quality tinned copper. Some reviewers seem confused by the color - tinned copper is silver and the core is copper. If it were aluminum wire it would solder very poorly, the color would be a matte silver instead of shiny and it would be much lighter. I soldered some of this wire and it takes the solder well, just like tinned copper.

Bought this wire bundle to install 8 LED lights on my bass tracker boat as I wanted them to be separate from the factory wiring harness. The wire ran through every nook and cranny with ease and seemed to handle the small current drawn by the lamps. I placed a row of four LED strips in one row and two sets of two 18w LED spotlights in the other row. After routing all the wire I had about 8 feet of wire left. Make sure you use a fuse between the power source and the lamps that is weak enough to…

I ordered a cable to install Rock lights on my truck. I started on the rear passenger side, circled the driver's side of the truck, my setup included a switch to turn the lights off if it's illegal, I hardwired the entire set of lights to my side lights, so when the side lights are on, rock that lights are on The wiring is one continuous piece of wire. The wire is very easy to work with, running it through many factory ties and adding your own if needed. I recommend using this cable for any…

Product meets expectations. This is the same wire as the wire on the LED strip, which is very handy. I also don't think it's aluminum because of the way it flexes. I think it's tinned copper. I used it to extend the connection for my LEDs and it worked great. Good price and fast delivery. I quickly installed the lights on the bedroom ceiling. I used three 16ft wires so make sure you have adequate power. The filaments I bought from Revain draw about 25w at 12v which is about 75w plus 20% for…

Wire ok but not perfect. Of course the price is good. However, I had a hard time working with the wire as it felt a bit stiff and difficult to remove. I was working outside in 52 degrees but it seemed unusually harsh for that temperature. I also found the wire gauge to be a bit thin - more than I would expect from a 22 gauge. The insulation was relatively thick and seemed to make the wire stiffer. The rigidity gave the wire the shape it was sent into and I didn't want to relax enough to do some