Header banner
Revain logoHome Page
exelair milton mini lubricator polycarbonate logo

EXELAIR Milton Mini Lubricator Polycarbonate Review

3

·

Terrible

Revainrating 1 out of 5  
Rating 
1.0
💨 Compressed Air Treatment, ⚙️ Filtration

View on AmazonView on ЯM

Media

(4)
img 1 attached to EXELAIR Milton Mini Lubricator Polycarbonate
img 2 attached to EXELAIR Milton Mini Lubricator Polycarbonate
img 3 attached to EXELAIR Milton Mini Lubricator Polycarbonate
img 4 attached to EXELAIR Milton Mini Lubricator Polycarbonate

Description of EXELAIR Milton Mini Lubricator Polycarbonate

FRL Air Lubricators: Extend air tool life and provide a continuous supply of oil. Durable cast aluminum body to resist corrosion. Rotating flow dial to adjust oil volume. Easy-access oil fill cap. Polycarbonate Bowl: Full, transparent view of fluid level. Bowl Capacity: 0.845 OZ. 1/4" inch national pipe threads on both inlet/outlet. Max Air Flow: 28 CFM. Max operating pressure: 145 PSI. Temperature range between 25°F and 140°F or -5°C and 60°C.

Reviews

Global ratings 3
  • 5
    0
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    3

Type of review

Revainrating 1 out of 5

Save Your Money - Awful Lubricator

According to my experience, the EXELAIR Milton Mini Lubricator Polycarbonate is a complete waste of money. It barely LUBRICATED anything and caused more issues than it solved .The worst part? It's marketed towards industrial and scientific applications..

Pros
  • None
Cons
  • Doesn't lubricate well, marketed towards industrial & scientific applications

Revainrating 1 out of 5

Disappointing Performance, Stay Away

This lubricator did not live up to my expectations. Through trial and error, I found that it did not effectively filter and lubricate the air in my industrial setting. The installation was also more complicated than anticipated... Overall, I would not recommend this product in the Compressed Air Treatment category of Industrial and Scientific..

Pros
  • None
Cons
  • Poor filtration and lubrication, complicated installation.

Revainrating 1 out of 5

No volume control

I could not turn the volume control low enough. The instrument manufacturer recommends "no more than 1 drop per hour". With 90 viscosity gear oil I could not get this lubricator below 10 drops per minute. With air tool oil it was at least twice as much. I emailed the manufacturer Milton but got no response so I replaced it.

Pros
  • Durable finish
Cons
  • Damaged