🔌 JoyReken USB 3.0 Header Extension Cable - 5.9 inch Low Profile 19/20 Pin Header Extender for USB 3.0 Motherboard Adapter Review

You know that. I know it. USB 3.0 motherboard connectors are thick and bulky and can mess up cable management cleaners badly. So get it You know what you want. It will solve all your problems except world hunger.

Just what I need! On Asus Z 390 boards, the front USB 3.0 port is on the bottom. This makes it impossible to mount the fans on the bottom of the case. At least Lian Li. It made it possible. Excellent work. I bow to you.

I had a few issues with my first motherboard assembly including an accidentally broken pin in the USB 3 port. I looked at different solutions and decided to try this low profile cable. This worked great and I stapled the cables together to make sure they didn't accidentally come loose and damage the motherboard. I'll probably use one of these in any future builds I make from now on. Thanks very much!

I bought this extension cable with plug because the USB 3.0 cable that came with the case was bulky and protruded so far that it touched the case fans and caused the mobo connector Deformation. I needed something thin and narrow that didn't stick out so much that I could buckle under the mobo and into the back of the case. It was perfect for this problem. Otherwise the cable works and performs as expected!

The lower right jack is broken and I had to take a look before continuing. He bent a needle on my MOBO. Also the connection is very weak. Bought two more packs from another listing (it's the same product), this time everything is perfect. However, the connection is still missing. This is a great idea and I think a lot of people need it, but it could be improved. Thanks for at least trying

The lower right outlet is broken and I had to check before continuing. He bent a needle on my MOBO. Also the connection is very weak. Bought two more packs from another listing (it's the same product), this time everything is perfect. However, the connection is still missing. This is a great idea and I think a lot of people need it, but it could be improved. Thanks for at least trying

For those of you with a reversible fan on the PSU shroud for secondary GPU cooling, this is the perfect solution. My situation here is pretty obvious. Like many people, I have to bend the USB 3 front panel cable 90 degrees and then again to install the fan. The connection block and manifold have to withstand enormous loads. I tried the adapter 90 degrees down, but the hole in the PSU housing still didn't match. Frustrated, I tried again to find a solution and settled on Revain. Found this…

I just got a new graphics card and it's so massive that the fan cover was pressing against the front USB 3 header/cable on my motherboard. This cable seemed perfect. I might plug it in and bend it so the graphics card doesn't put pressure on it. I took the cable, took out the graphics card, connected this cable and connected the connection cable to it. It wasn't until later that night that I was working on the PC and plugged the USB drive into my front ports and it took a minute for Windows to…