🔌 Mitsubishi Factory Radio Stereo Amplifier Sub Interface Wire Harness + Inline Converter: Optimal Compatibility Review

Worked great in my 2015 Outlander Sport. I was also able to power/ground my rear camera and avoid splicing standard cables!

Works great on Outlander Sport 2016 I'm glad I didn't listen to the seller said there was no wiring harness for your car. I didn't use it to keep my factory stereo, instead I installed an Android stereo and RCA connectors.

I took a chance with this suspension as I really didn't want to make a connection with the factory cables and after a little research I found that the Outlander Sport has the The Lanzer shares the wiring. I'm glad I did this and it works great with my 2018 Outlander Sport.

Previously worked fine on my 2010 Outlander OEM radio (not Rockford Gosgate). although it applies to this device. UPDATE - My FL speakers stopped working or turned off. Removing the adapter is not a problem. I do not recommend this product based on similar reviews from other reviewers.

I took a chance on this wiring harness because I really didn't want to get stuck in the factory wiring and after a bit of research I found out that the Outlander Sport shares wiring with the Lancer. I'm glad I did this and it works great with my 2018 Outlander Sport.

I'm an amateur installer so I was quite intimidated by this setup. Other than that, I just followed the instructions step by step and everything worked perfectly. All cables attached to the stereo wiring harness and many colors matched. It is actually quite simple

This worked great on 2018 Mitsubishi Outlander Sport with base model radio. It was easy to install. You remove the factory plug from the radio, connect the matching end of the adapter to the radio, connect the original wire to the radio with the other end of the adapter, and you're good to go. Simple and easy.

Worked on my 2017 Lancer ES. This small wiring harness allows you to use your factory head unit subwoofer. No more fiddling with speaker cables for line-in. It's plug and play. My subwoofer hits just as hard with this LOC harness as it does when I hooked it up to a Kenwood 2V RCA deck. Either way, for less than $15 and 30 minutes, I got incredible bass from my factory. XU. The wiring is of the same quality as any other kit I've used.