Fan for Arctic P8 PWM PST case, black Review

When developing the fan for the PC case Arctic P8 PWM PST Black, article ACFAN00150A, special attention was paid to directional airflow. Thanks to the 4-pin connector, the RPM can be adjusted over a wide range using PWM. When developing the new P8 PWM PST, particular attention was paid to focused airflow and thus high static pressure. The fan guarantees extremely efficient cooling even with increased air resistance. Even at low speeds, the sound of the new arctic engine is barely noticeable. Due to the sinusoidal magnetization, the new motor only generates about 5% of the vibration of switching a conventional unfiltered DC motor. Hence, there is no need for rubber gaskets due to the new engine''s steady and smooth torque. A 10°C lower motor temperature approximately doubles the life of the fan. The new Arctic P8 PWM PST motor has four times longer life thanks to the low coil temperature. Thanks to the 4-pin connector, the speed can be adjusted over a wide range using PWM. In this way, noise is kept to a minimum and maximum cooling performance is guaranteed when needed. Thanks to the combination of alloy and lubricant developed in Germany, the friction inside the bearing is reduced and greater efficiency is achieved. As a result, less heat is generated, as well as less noise from the bearings, which means you can enjoy a longer life for your fan. Double-sided installation is possible, for blowing cold air or blowing out heated air. Fan speed: 200 - 3000 rpm Airflow: 23.4cc m / 40.3 m3/h Static Pressure: 1.9mmHg Art. Noise Level: 0.3 Sony Operating Ambient Temperature: 0 - 40 °C Fan Control type: PWM PST Connector: 4-Pin Male + 4-Pin Male Hydrodynamic bearing Electrical Specifications: Voltage: DC 12V Start Voltage: 3.4V Current/Voltage: 0.09 A / 12 V Cable Length: 400mm Size and weight Length: 80mm Width: 80 mm Height: 25mm Weight: 81g