10 Pairs of Finware XT60 XT-60 Male Female Bullet Connectors Power Plugs with Heat Shrink for RC Lipo Battery Review

These are really solid connectors. I used them to make it easier to connect/disconnect speaker wires in an overhead soundbar. They have a very solid and tactile feel when plugged in, and it takes quite a bit of force to disengage them to prevent accidentally disconnecting them. The soldering was a little tight as there isn't much of a metal preheat connector protruding from the connector, but if you have a good iron this isn't a problem. The plastic did not melt or deform during assembly. The…

I like that this set has 10 male and 10 female XT-60 connectors and comes with red and black heat shrink tubing. It comes in a full tube and you can cut off as many tubes as you need. I used 18 gauge copper wire but I think it should have been 16 gauge. I recommend using solder paste when connecting wires to the XT-60 connectors (and don't forget to put some heat shrink tubing on first). I consider myself a beginner but was able to successfully and reliably solder the leads. I used this to…

At first I wrote over 500 reviews. 99% where are rc products! I only gave maybe 30x 5 star reviews! This product had + and - marks on each side, which was a first for me. Pretty cute, no question! The solder went to each terminal very easily and they didn't turn to mush after some heating. I used #10 wire with them and they had a nice deep pocket that most wires fit nicely in. I overdid it for my project *the wire is usually 12 or 14 used with them. Whatever you use it will be beautiful! They…

Purchased for Creality Ender 3 Pro 3D Printer. There were many reports that the XT60 connectors on these printers were of lower quality, so I paid and watched myself closely. On magazine printing projects I found that the plugs get very hot (so hot you can't hold them with your fingers) so I decided to buy them to replace the plug. One of the results I found and was impressed with was that the new ports got slightly warmer than room temperature, I wasn't expecting that much of a difference…

Overall excellent quality. While these things are primarily used for RC projects, I use them for general use when I need low voltage connections that will give decent performance. I'm rating them 4 stars instead of 5 because instead of individual small shrink pieces, there were several large pieces in the pack. That's usually fine with me, except once they're cut into individual pieces, there's no way they can be as long as the individual pieces, so overall it reduces the number of tubes…