🚽 Fluidmaster 555CRP8 Universal PerforMAX Toilet Flush Valve Repair Kit - 5 Minute Solution, 2 In. Review

It was fitted to replace a Fluidmaster damper set which is no longer in production. The device is not very good. The amount of time it stays open is inconsistent - sometimes you get almost a full tank, sometimes less than half a tank. It doesn't matter where the "dial” is installed on it. And about one in ten times it never returns to the closed position, only floating about half an inch above the bowl entrance and the water just flows. The chain that lifts it up is the right length with the…

My flap seal was starting to leak, but it was so slow that I wasn't sure what the problem was. At first I just replaced the shutter and it worked for about 2 weeks, after that the same problem. I ended up with a bad gasket under the shock, not the shock itself. I bought this kit which has everything you need. I was worried how I could get this bad seal. I tried to just pull it out with my fingers and it popped right out. I then dried the area overnight and then installed this kit. Make sure you

I installed it according to the instructions and everything was fine until I tried to fill the tank. there was a clear leak. Thinking it was the sea's wrong installation, I took it off and ordered another one. But since a new replacement gasket arrived nine days later, I settled on a sealant that contains butyl rubber. After reinstalling the device I tried refilling the tank but it still leaked unless I pressed down to make sure it was leaking. As the pressure was released, I watched the water…

I bought this because after installing a new toilet cistern kit I couldn't adjust it properly and the bolts holding the valve assembly started to rust and I unable to tighten it. I found this valve replacement and thought I'd give it a try. I didn't want to remove the tank unnecessarily. Wow! It worked fantastic! The hardest part of the installation was making sure the tank was clean and dry. Just in case, I made a slightly roughened area with a simple nail file. I aligned the new valve…

Installed on my leaky toilet, whole process took less than 10 minutes, very easy. A few tips: 1) Make sure the surfaces are completely dry and clean - I rubbed some rubbing alcohol on the drain lip and then dried it completely with a paper towel 2) Not sure if this helps or not, but I have all the areas to be heated with a hair dryer also slightly heat the adhesive surface of the replacement flush valve 3) Be careful when removing the backing paper from the adhesive, work slowly and when you…

Product is easy to use. The old damper kept popping out of the bottom of the damper. Pull the chains, it will break. I had a box of crackers left over from replacing the crackers at church. The new flaps on my toilet were still coming off. Finally it dawned on me that the levers on the lower assembly were worn out. The raised edges on either side where you snap the flap have been worn away, allowing the flap to slip off when pulled. Holes in different toilets have different sizes. ** There are…

I bought 2 of these Fluidmaster 555CRP8 Universal PerforMAX 5 Minute Flush Valves just because when I look at their picture they seemed intuitive they to be a good choice for toilet flush valves. After carefully following the instructions that came with it and watching a video of a young black haired man (who is probably the circus salesman for this product) showing how to install this Fluidmaster hook ring toilet flush valve, I installed the first of these two rinses. valves. After that, after