🪚 Enhance Your Woodworking with Freud Double Flute Straight 12 115 Review

cuts well, very well. no burrs or chips, no vibration, just milling, using it in a plunge router for slotting so I use the full diameter of the drill bit for cutting works great

Well balanced and perfect dimensions so sharp. One issue was with the packaging, although it was well packaged I literally couldn't get it out of its holder. I had to knock it out with a hole punch, and even then there was a rubber mount that had to be cut off with a razor blade. That's something Freud should work on because it's not something that can be kept in its original packaging.

I used these bits to make a 16 foot long tongue and groove from used treated yellow pine. I run the cuts over the router table and make two cuts down the full length of the bit to get an overall depth of about 3/8 inch. So far I've had to replace two of these bits, but only after driving in the hidden nails. The bit I'm currently using cuts great after I've cut about a half mile of sheet piles. For the work I do with these bits the cut quality is not a concern, but they cut cleanly and in my…