Frigidaire 807117001 Drain 💧 Hose: Optimal Water Control and Convenience Review

Bought for a dishwasher that I bought on sale because it didn't include it. It has worked great so far and it turned out to be an easy setup for the guy who installed my dishwasher.

Unfortunately the 'universal' drain hoses available at your local hardware store do not fit the large fitting under the dishwasher. This is an OEM part, fits exactly. Hope it lasts longer than the old one!

The hose fits perfectly in my dishwasher. The square rubber end is slightly different, but I had no trouble attaching it. Pulling out the dishwasher, replacing the hose and checking for leaks took about an hour. Easy repair with the right spare part!

Bought a Lowes dishwasher and the hose that came with it didn't work with our waste chute so we bought 2 more from Lowes which still didn't fit so we finally saw this after watching the YouTube video had hose and it fits perfectly!

Fits our Kenmore Elite Fridge perfectly. My husband needed a hose after finding a leak which he installed in minutes and while we change our filter regularly this clean new hose definitely improved the taste of the water and ice in our fridge.

This drain hose is an exact replacement for my Kenmore 587.15263900. The pump end of the dishwasher is 1-1/4" ID, the hole at the end of the sink is 7/8" in diameter that can be reduced to 3/4" or 5/8" with markings on the hose to the easy trimming with a carpet knife. For my dishwasher it was necessary to trim them down to 5/8" to fit properly on the air gap y-bar. Be sure to install and tighten the clamps on both ends or there will be leakage later can.

This was a must have for my used dishwasher but this part was missing. Unfortunately this is NOT a standard size you can buy at a hardware store so I had to buy one specifically for my car. Although the quality is good and I doubt I will have to replace it. Since it was made for my dishwasher, it fits perfectly and sits snugly in the machine. If your machine needs that specific part, don't waste time looking for a universal part to match, get it right the first time. This saves you from wasting

Perfect fit, exactly the same hose as my dishwasher. Two rubber fittings are glued to each end, making it impossible to swap them out if the fittings ever wear out, which was the case in my case. A much more practical design would be a compression fitting or compression fitting so the rubber fittings could be replaced for about $4 instead of the $30 for a new hose and I would have to take my dishwasher off the shelf. It would be even better if my dishwasher had a drain fitting about 1/4 inch…