Gauge Premium Extra Flexible Welding Review

Cheap patch cords suck so I just had to make my own. These cables are just the ticket to the highest quality patch cords! I connected them to US made clips and wow! 100% copper wire paired with copper terminals is what you need. HIGHLY RECOMMENDED!

The wire appears to be of decent quality but it definitely appears to be under 4 gauge as the wire had a decent slack in the 4 gauge ring terminals I soldered to. Same goes for the Caliber 1 I bought. My wires are pretty short so the smaller size doesn't matter, but it still can't be the actual 4 or 1 gauge as advertised.

*EDIT* After a few years this cable has had no problems. 100% happy with this purchase so far! The cables are better than the super expensive cable I bought from my local stereo installer! Worked great to parallel my batteries in my inverter escalade. I did a lot of research and his cable offers the best value for money. I get the expected voltage readings after installation.

I bought them after researching many manufacturers' products. I use them to install a 3000w inverter in my trailer. These cables are fantastic. They are exactly as described. 100% copper. Beware there are many companies trying to sell the same product but if you research their products you will find that others are selling copper clad aluminum. It is in no way the same as this product. Do not buy inferior products

Used for audio cables and is slightly smaller than "oversized" audio cables found elsewhere. That being said, it's rated at 300 amps, which is exactly the amount I have installed in my car to easily power all my peripherals. Although the outer shell is thick, I was able to cut it about halfway with a utility knife and rip the jacket off with my finger. In addition, the cable is very flexible considering its size, making it well suited for use in vehicles.

So far, so good! The cable is in fact made of pure copper and is flexible enough to be routed inside or along the car. I used it when updating the battery wiring for the rear shifted battery in my RX7. Immediately you noticed quicker starts, a smoother overall tension across revs and the car just feels happier. The shield appears to be quite strong, but it's easy enough to cut with a razor blade in preparation for crimping the ferrules. I used a plastic loom around mine for extra protection as…

Without a doubt one of the best 1/0 gauge wires. I bought the black wire and the red one is also 1/0 but I can definitely see a quality difference between the two. This product has more strands of wire compared to the cheaper 1/0 red wire. I use this to increase power 3 and starter battery on my ls swap. I ordered 15ft rolls and have plenty left over when I install my sound system. I will order a 2/0 gauge to run the power wire from the battery to the trunk. Don't buy cheap and get it

Good high performance cable. Used it to move the battery in the trunk of my car. Lots of wire racks and good thick insulation. The cable is quite flexible. cutting advice. If you don't have a cutter that can cut this thick cable, don't try to cut it piece by piece with wire cutters. This will mess up the strands and you won't be able to push them back in, and if you crimp the right size terminal it won't fit. I don't have a cutter, so I stripped about an inch of the insulation where I wanted to