🔥 Gibson 500415: Premium Polished Stainless Steel Exhaust Tip for Enhanced Performance Review

The tube fits perfectly on my 2013 John Deere 1025r. Firm but sliding fit on protruding exhaust pipe. The 5/16" nut and bolt that came with the pipe are plated steel. I also replaced that hardware with stainless steel so there is no rust anywhere.

Perfect fit for my John Deer 1025R. Slipped right in with a little help. The only thing you should pay attention to is the clearance of the tires. You should aim it slightly at the frame so the tire doesn't touch it when it's fully blocked. But it's much better than the factory design!

I need this for our generator power on our mobile home. It was very tight and I had to widen the Gibson to fit over the exhaust. I found that a little oil helps it slide. The original fell off and I hope the Gibson's fit is retained.

I love the polished SS tip on my Class A exhaust. I cut the factory pipe behind the support bracket, installed the tip and replaced the bracket with the tip . This tube is very durable, very well made and looks great. I am very happy with the results.

Looks much better - love the stainless steel and fit&finish! Recommended for onan generators with this exhaust. I cut off the piece shown in the photo, plugged in this new part - fits and looks good It took longer to get the tools than it did to install.

Don't buy this if you don't want quality. This is a work of art and worth every penny. In a few years I will appreciate that this is stainless steel and not a cheap galvanized tip. If you want something to last, this is it. Bought to fit the exhaust to the generator in our RV. Worked smart.

This tip is made of strong and heavy stainless steel with a perfect chrome finish. I would like the manufacturer to provide the exact dimensions of this tip. To save you the hassle, the inner diameter of the tip is 1.48 inches. This makes it a perfect match for most 1.5 inch exhaust systems. While this was not the manufacturer's fault, the muffler's outer outlet diameter for my application was 1.63 inches. It's too much to hydraulically expand the slotted end without disconnecting, so I hired…