🔧 High-Quality GOOFIT Carburetor Carb Replacement for GX340 GX390 188F Engine Motor 11HP 13HP Generator: Boost Performance & Efficiency! Review

Perfect for 212cc HF Predator engine. The only problem is that the fuel filter shown in the product image is not included. I unscrewed it straight away and started the first train. The original carburettor only worked with the choke closed (even after thorough cleaning). This carburettor solved that problem and the engine runs great. I didn't even have to set anything!

Buy this! Works great when there are native seals. The one between the mounting surface and the manifold is not shown or included and would be difficult to manufacture as it has a slot. I originally bought one from Poweka which was too flimsy and caused jumps at high speed. Secondly, if the seller reads, the bottom picture of the seal is not for this application. The figure below shows the correct seals. Thanks DS

I bought this carb after having bad gas with water. The price of the carburetor is good enough that it wasn't too difficult to just swap it out instead of trying to disassemble and clean the old one. The only thing I disagree with is that the picture shows some sort of filter at the end of the fuel hose, I didn't have that. But I can't complain too much, for $18 I'm happy. I installed the carburetor in less than 20 minutes and the engine started on the first pull.

I got a generator set that has sat for 3 years on old petrol. Since the generator set was 20 years old, I knew from the start that the carburetor needed a major overhaul. Instead of spending two hours disassembling every part, cleaning every part and reassembling, I spent 16.00 to buy this carburetor. turned the key and the generator roared, it runs smooth as silk. At 4:00 p.m., even if your carburetor is not fully fired, it costs money and time to replace it. Especially if you live on…

I bought this for two reasons. #1 was under $12 with shipping when my local small engine repair shop said a replacement would cost $50-$75. #2 was the price - I wasn't sure if the generator would even start after I cleaned the gas tank, which was riddled with rust, and I didn't want to spend $50-$75. Anyway, I cleaned the tank - and while waiting for it to dry (used phosphoric acid) I pulled the carb out of the box, installed it, then built a 1 gallon tank and fuel line to try to start the…

After being foolish enough to leave gas on my Harbor Freight / Chicago Electric Generator since the last time I used it, the engine would not even start with electric start. After realizing what was wrong, I contacted a few local repair shops and found that it would cost me at least $70 just to have them look at it. A guy told me that if it's a carburetor it's about $200 each and it's going to take about 3 weeks before he can even look at it and another 2 weeks to fix it once he gets the parts…