🔧 Harbor Tools Grommet Installation Kit 30037 Review

Wow, if I could think of a stronger word than trash, I would use it here!. The punch tool was very blunt. I sharpened it on a bench grinder and it cut two holes in the canvas before blunting because the metal was very low quality. After installing most of the 50 sets of bushings, the tool's head grew a lot due to poor quality metal. It goes in the trash. Hopefully the cheap aluminum bushings will hold up. What a waste of time and money!

1. The sleeve is made of the thinnest possible material.2. The stamp will not cut unless you apply it to concrete which will damage the stamp even after a few uses. A puncher is enough to make a mark telling you where to cut.3. 103 pcs mainly consists of 3 bushing installation tools and the bushing kit itself.4. A set of 100 bushings won't fit 1 to 1. I have more washers than the main bushing itself so basically I only have 37 pairs instead of 50 pairs. more expensive much better quality.

I found them to be of very poor quality. I suspect that almost 1/3 of the base block (the half that fits the hole you cut) was already bent and deformed when the package was opened. They're made of aluminum so light that I think they'll warp if you just put them in vinyl wrap. I sorted the stack, threw the misshapen one in the trash and used what was left. The ones that were in usable shape worked pretty well: the punch cut well and the crimping tool got the job done with ease. The finished…