🔌 BeltandRoad Dual Beam Headlight Splitter Harness Adapter: Enhance HD Road Glide Street Glide with H4 Splitter for Dual Beam Headlights H4 to H9/H11 Review

This adapter harness was the third other 1 I've tried from Revain and was given it precisely because the picture shows a notch inside but it isn't , so that it can be plugged in again. More Chinese junk.

Great value! I have a custom 2018 Streetglide and I replaced the stock headlight with LED. It worked perfectly and at the right price. No complaints, looks standard quality and should last.

Easy to connect adapter for my Harley LED headlight; works well. I simply unplugged and removed the stock bulb and then hooked up this wire harness to the new LED and then to the bike's original headlight wire. It's pretty obvious which end goes where.

I thought I bought the wrong trailer, it turned out to be wrong. Pay special attention and make sure that the black wire does not work with the factory black wire, blue with blue, red with red, or high beam. The plug will fit anyway, so it's pretty easy to plug it in wrong

The headlight comes with an adapter but I ordered it without realizing it, kinda glad I did. This wire is a lot heavier so I used that instead of the one that came with the light. I don't know why but the plugs allow wrong plugging and the light won't come on. If that happens, simply unplug, rotate 180, and plug back in to solve the problem.

For 2014 Street Glide model Benefits: - Plug and Play - Approx 15-20 minutes to fix your wrong wiring diagram. / The male portion of the connector is open about 1/16 inch - connectors that plug into bike straps are cheap - not a halo light connector - to get the light to work I had to pull the connectors out of the housing to find out the correct power/ Connect Sequence - The wires are loose in the connector housing, which can lead to a short circuit when disconnected

This review is for the splitter harness adapter only. I'm using it on a 2014 VRod Muscle to replace the stock headlight with a JWSpeaker unit. The standard headlight has two bulbs with H9 connectors and the JW speaker comes with H4 connectors, this harness pairs flawlessly with two. Just a tip: To avoid blowing the fuses, DO NOT connect both connectors from the bike to the wiring harness when running the setup. Take the low beam connector and align the black (negative) wires, connect it first…