💻 6/8 GPU Steel Open Air Miner Frame Rig for Cryptocurrency Mining - HELOIA Mining Rig Frame (Frame Only, Fans & GPU not Included) Review

For $60 I think it's some kind of plagiarism, it definitely fits the bill, but the materials seem flimsy and flimsy. Assembly is also quick and easy, but the instructions are tiny. Definitely should only cost around $30.

If it was $20-30 it would be a decent price. For over 100€ I had expected something harder and of higher quality. Pretty below par.

Make sure to put the bar on the back, not in the middle, otherwise the graphics card screws will have a gap of about 3mm. Pretty simple design. But it works well and reliably. A minor annoyance is that there isn't a good spot to install external fans. Note that this only works with a maximum of 4 cards to allow enough space between them for ventilation. I made a template with 2 screws + 3 spare slots in between which works fine for the optimal card temperature.

Good product. For a beginner it will be difficult due to the small number of assembly instructions. Also, it would be helpful if you could change the power switch to allow it to be installed (e.g. when drilling a specific hole).

I had a Dell motherboard. A hole had to be drilled in the frame and the thread cut. But I also had an ATX format motherboard that was a great fit. at a fair price. Was next business day. If you're having construction problems, don't mine.

Overall excellent frame of outdoor mining rig. To install; super easy and includes clear instructions. Everything is aligned and screwed without any problems. Price; almost double what you would expect. Delivery; Fast delivery with Premier. Delivery in about 4 days.

Make sure that the strip is placed at the back and not in the middle, otherwise the graphics card screws will be about 3 mm apart. Pretty simple design. But it works well and reliably. A minor annoyance is that there isn't a good spot to install external fans. Note that this only works with a maximum of 4 cards to allow enough space between them for ventilation. I made a template with 2 screws + 3 spare slots in between which works fine for the optimal card temperature.

This is an extra strong frame, the sheet metal is a bit thin but powder coated. We understood each other without any problems. I know they give measurements but it was slightly smaller in real life than it looked in the photos. Big enough to support an ATX MB and a standard desktop PSU underneath. I only have three cards at the moment, but I'd be fine with six cards. I think if you tried to go further you would choke and run into overheating issues when it comes to dual slot cards. I paid a…