🔧 Hitachi 998839 Switch 1P Replacement Part for C10FS/H/B: Find the Perfect Fit! Review

This switch broke after about 10 clicks. They want me to send the whole saw, not just a new derailleur. I'm not happy at all

Yes it was a simple direct replacement for the original trigger switch. Just a word of warning, three set screws are NOT supplied. You have to take them over from the old Switch. So don't throw it away.

I received this part and it was exactly like the original. Another review stated that no screws were included, but this is not the case. They weren't in the counter, but they were with him. Couldn't be happier.

My old saw stopped working. The last few times he's sneezed, then stopped, then stopped. I thought there was little chance of finding a switch for such an old machine, but I punched in the numbers and here it is. Easy to install and saw in working condition. I'm happy! Much cheaper than a new saw!

You could use the schematic because my friend made a mistake with the wires and swapped them. I knew it was just contacts. But their cleaning did not last long, since the rod when the contacts wear out over time. I bought this and saw that it works great. I also thought the brushes were just the reason. Five stars. Buy and done!

My Hitachi C10FCH2 miter saw had a faulty switch that was stuck in the on position. It wasn't perfect for the saw but it worked to replace the broken switch and I can safely use my saw again. After taking this photo, I wrapped duct tape around the handle because there was a gap that would fill with sawdust over time. Gad spent $15 to fix it, not a few hundred to replace the saw!