🔧 High-Quality Stainless Clamps for Adjustable Hydraulic, Pneumatic, and Plumbing Systems - Hon Guan Review

Used these clamps as driveshaft counterweight so they pretty much abused my centrifugal force as we as nature lol. Pretty good clamps don't rust at all, and the clamps have so far held their strength for over 30,000 miles. If this was helpful, please click the helpful button 😀

A little awkward to use. For those who don't know, unscrew the screw to loosen and take off the other side of the ring. Turn the right screw clockwise to tighten. I always thought you could just feed the other side, but the whole device is controlled by one screw. I hope this helped someone and they don't waste an hour trying to figure it out. For example, I prefer instructions.

Anyone else concerned about tying the probe to the underside of the trolling motor? Directly behind the spinning propeller. is it smart It kind of looked like waiting for an accident, so I went with a stainless steel clamp. It fits perfectly with my Garmin Striker 4 built-in GPS fish finder through the included bracket. I wrapped the motor in thick aviation black tape to protect the paint and the included rubber grommet under the transducer. Now I'm sure I won't find the sonar wire wrapped…