🔝 Enhance Your Ironing Experience with Household Essentials Ultra Plus Ironing Board Replacement Pad & Cover featuring Silicone Iron Rest Pad - Natural Canvas Edition Review

Preserved and applied. It fits my board snugly and it would be nice if the attached batting straightened out. Everything is lumpy. There are about 4 different spots that are not stitched very well. I love the outer fabric but wouldn't buy it again. What should be tight should be cut a little better.

Bought a used ironing board with this cover. I have burned many ironing board covers in the past. No longer! If you have an iron with an auto shut-off, remember that if you leave it face down on your pillow for too long, it will turn itself off. I even cut out a silicone pad from my old case and saved it just in case.

Fits well on my board with good fit. The canvas material is thinner than I expected, but that's ok. I hate the bag on my side; Not sure what it is for as there are no instructions or product description with a lid. Plan to cut it off. I need to iron before deciding whether to take the iron off; it remains only to cut the seam to remove it. In general, I like the ironing board cover. thank you mother

If you have an ironing board of this size, this cover will provide a great fit. The cover does not move or detach from the board like my previous cover did. It is well padded and the Velcro fasteners are easy to adjust. I would like to warn that this is not a metal surface, so it is not smooth. So when you use steam, the ironing tends to stick, so you have to separate it to move it on the board. It's not heavy, but if you're used to a slick surface that makes it easy to move your clothes…

I was curious to buy it because I do a lot of manual work (professional work in the clothing industry). In combination with an ironing board, I use a professional steam iron with a Teflon leg, which I prefer to place on the board than on its holder. This product had ideals. Attached silicone mat, cotton webbing for easier vaping, webbing for a custom fit. What could be wrong?!? I opened it up and attached it to my board, which for my purposes has a melton base layer. The fit was a little tight.