HTTMT MT390 006 Compatible Kawasaki 2005 2008 Review

Looks great, a little difficult to put on. One of the brackets didn't have the right bend to attach it properly, so we bent it again ourselves and it worked. It was said to be a perfect match for our Kawasaki 636, and for the most part it was.

This product has been great so far. I have a 2006 zx6r and my bracket broke while stepping on the pedal and needed an affordable replacement. It fits perfectly without any mods. The only reason I gave it 4 stars is the quality but for the price I can't complain it's holding up well so far!

Looks like good quality except the pin springs are too short so you have to bend the tip of one piece to make it work properly, although this will scratch the paint at this point, and you'll also need to bend the fin that bolts to the pin mount so it doesn't pinch the rear brake fluid line. Not very difficult to do.

I will definitely not be buying again, product does not match the motorcycle in any shape or form. The pedal wouldn't attach to it with enough slack to move and broke the piece in half at one of the brackets that attaches it to the bike. With that, I could leave a starting score of 0, I would. Contacted the company several times and got no response. DO NOT SPEND YOUR MONEY ON IT

On the image uploaded with this review you can see the pin that comes with the bike. It is a chrome pin which is clearly broken (separated) I bought a new one. However, the one sold has a coating that makes the pin thicker and does not fit in the brake pedal groove intended for it. Not to mention it's not smooth. Even when it fits, it doesn't allow the pedal to run smoothly, if at all.

Just what I need. Bought for a 2007 ZX6R because the bottom of the right hand rider bracket broke off and the brake pedal came loose rendering the rear brake unusable. Installation was easy and didn't take long. All I used from this kit was a bracket because my bike is silver and I wanted to keep the stock footpeg and heel guard and it was better than paying $50 + JUST ONE bracket. I gave 4 stars because the brake light bracket is slightly different.

The pegs were difficult to assemble, but I managed. These pins ARE NOT SUPPLIED WITH MOUNTING SCREWS and I had to make several trips from the parking lot back to the hardware store to find the right length, diameter and threaded stud. Once in place, the pins themselves feel a little flimsy. It's not bad, but once the stylus is fully extended, it will extend just over 90 degrees if someone pushes down on it. It's not scary, but it's something to consider.