Hyperkin FreeStep VR Cable Management Solution for Enhanced Gaming Experience 🔌 with HTC Vive Pro/ HTC Vive/ PS VR/ Oculus Rift (6 Sets) Review

First, they work great. If you're here for VR needs, this is for you. I bought them, like many others, to route the Oculus Rift cable across my ceiling and down towards me, rather than being strewn across the floor if I trip over it and trap one or both feet in it. I installed them and they work fantastic. I just want to clarify something. Someone posted a review saying they can't use it as advertised because the factory put glue on the pulley and not the mounting plate. Not 100% true. While…

It took me about 5 hours to figure out the right way to do this with my setup, but after that it works great! I lost maybe 2 inches of clearance around the edges because of the length of the retractors, but it's worth it. I just tried Holopoint, which is pretty much a "torture game" to set up cable control. I didn't even notice the cable (it hit me several times from the top of the head, but it never bothered me). If your rig is smaller than mine (about 4 meters long) you don't have this…

The clips provided are terrible - just not in the way. You are as bad as can be. Next, glue is dangerous, and unless you plan on spending (and I'm guessing here) 5 minutes, heat it up with a hair dryer and carefully remove it. from your walls or ceiling I wouldn't recommend that. One came off on its own and I didn't see any damage to the wall, but I trust other reviewers enough not to risk damage. After all, the cables just aren't strong enough. Once they go down, they don't go up until all the

First of all they work great. If you're here for VR needs, this is for you. I bought them, like many others, to route the Oculus Rift cable across my ceiling and down towards me, rather than being strewn across the floor if I trip over it and trap one or both feet in it. I installed them and they work fantastic. I just want to clarify something. Someone posted a review saying they couldn't use it as advertised because the factory put glue on the pulley and not the mounting plate. Not 100% true.

Took me about 5 hours to get my setup right the way it was, but after that it works great! I lost maybe 2 inches of clearance around the edges because of the length of the retractors, but it's worth it. I just tried Holopoint, which is pretty much a "torture game" to set up cable control. I didn't even notice the cable (it hit me several times from the top of the head, but it never bothered me). If your rig is smaller than mine (about 4 meters long) you don't have this problem at all. I've had…