🚗 iJDMTOY Smoked Lens Amber/Red LED Side Marker Light Kit for 03-09 Hummer H2, 180-SMD LEDs, OEM Replacement Review

They don't fit snugly on the roof of the truck which can result in water getting into the frame - they took the elements back so that's a plus - design flaw

These lamps are beautiful! The quality of the lamps seems to be very good. They are always on while my H2 is running. Installation was fairly easy using basic hand tools. I highly recommend them as an upgrade for any H2.

Very modern look and much better than standard indicators, long LED strip instead of 2 small bulbs. And the tinted lenses look very dark compared to other brands. Plug and play app. Access to the rear connectors is quite difficult to prepare for dismantling the rear inner panels.

Wires are very thin. Care must be taken that they do not break at the soldering point. Center lights were not connected. They had to be forced. Not sure how long they can last and vibrate. The headlights fit perfectly. I don't know why the other one didn't do it. The lenses looked beautiful. I don't know how long they will last.

Definitely a great price, fantastic lights, fairly easy install. The hardest part is attaching all the plastic panels on the back to access the wiring harness (on top of the rear wheelhouse). Once you've removed or almost completely removed the panels, you're good to go. The fronts were the easiest and lasted a maximum of 2 minutes. The back took about 20 minutes, no tools required except strong fingers to remove the interior panels! They look perfect and work very well! No problem, no fuss or…

Very happy with her looks! I made the front and back in about 30 minutes. The fronts lasted about 5 minutes each. The key to easy rear panel design is to remove the rear speaker trim at the top of the right and left sides of the tailgate, then pull out the lower rear trim closest to the tailgate on both sides. It is only necessary to press his back, which creates an opening in the back large enough to fit a hand and about half of the forearm. It took about 10 minutes for each side. For the…

I LOVE how beautiful these lights look. The front blocks are very light. A Phillips screwdriver removes the old lantern. Side cutters loosen the drawstring on the hood. Please note that the lights do not come with a factory replacement wiring harness clip that secures this wire to the side of the bonnet. It's just a zip on a dip mount. I can live without her. I haven't tried rear blocks just because they work and it's harder. In my case the right front headlight failed and this kit was MUCH…

It took about nine hours to sort through everything I had already done with the headlights and fog lights. After you've cut all the soldered lithium-ion wires, traced the wiring harness front to back, disassembled the dash and almost all of the plastic covering the wiring harness in the car, look for a short as the taillights aren't working properly. It's been a great day so finally I said screw it in and put the old ones back in and everything works fine after I put it back together front to…