IJDMTOY Headlight Conversion Relay Wire Harness: Original 🔌 H4 Headlamps to Separated 9005/9006 High & Low Beam Headlights Review

"works" but only after diagnosing a problem in the relay connector. One of the connectors inside did not fully engage and was pushed out from the bottom of the connector. After some "adjusting" with cable ties, everything works.

works but the wires need to be 6" longer especially ground wires. The high and low beam connectors are also the same, although they should be slightly different. Switching on the high beam takes a lot of energy. it works, but it needs a lot of tweaking.

Does what it's supposed to, fits right out of the box. Added bonus: keeps low beam on when switching to high beam. (Didn't know this when I bought it, so it was a little interesting to check which plug is which (low/high) to say the least). Note. It is equipped with four (4) plugs 9006. Lamps (9005) must be replaced with 2 plugs. None of the 4 connectors are labeled to indicate that they should be (low/high beam). 9006 = low beam (typically 55 W) 9005 = high beam (typically 65 W)