🔌 269 Motorsports 2-Wire Injector Connector IPR Valve Pigtail | Compatible with 6.0 7.3L Ford PowerStroke Diesel Engines Review

The connector on my 6.0 did not fit into the IPR, it is of extremely poor quality. When I gently tugged on the wires to make sure the pins were secure, one of the wires fell out. Don't waste your money. Go OEM.

Suitable for intellectual property, but not tight and does not fit. There were a few extra tabs that the manufacturer didn't have. I would look elsewhere if I had to do it again. 2003 7.3

If you're an idiot like me and accidentally broke a clip while replacing a pesky IPR valve? Fear not, this braid substitute works great. Just make sure you solder it.

I had one of the wires from my factory wire connector so I ordered this connector. Not only did this fix it for me, but it also caused the occasional idle vibration that I've had for over a year. The shielding was good and the wire gauge appeared to be slightly larger than factory.

If I could give this product a negative review, I would. This is complete rubbish, don't waste your time. Inner connections don't persist when you try to connect. Luckily, before I went any further, I realized who knows how long it would take to realize that the 'new' pigtail I had installed was utterly useless. I ended up cutting off this pigtail and soldering back the factory.