🌡️ Inkbird IHC200 ITC308 Pre-Wired Combination Temperature and Humidity Controller with AC Dual Stage Outlet Thermostat for Cooling, Heating, Humidifying, and Dehumidifying Review

Temperature/humidity control programming is confusing. In the end we managed to work close enough to the desired effect.

Save money and buy quality product. Bad consumer support. They make products with imprecise moisture control that fail instantly. Sensors last a month at best Pure garbage _

After I set it up, it works great. It's nice to have temperature and humidity control in one device. The instructions were confusing due to poor English translation and the programming menu wasn't the best. However, it didn't take long for me to figure it out and get it. To work.

Temperature controller does not turn off when all three buttons are pressed and held. It must be disconnected from the network, and after disconnection all settings will be restored to default. The humidistat is turned off by pressing and holding all three buttons. My custom settings remain in effect when the device is turned off and on again.

He (fault) on the humidity unit is due to a sensor. The device worked fine at first, but eventually started with a long continuous beep due to a bug. I swapped the sensor for the one on ebay. The sensor looked different, but it works. You can also buy it on the Inkbird website. I was able to just connect the wires from the old sensor to the new one. My device is out of warranty.

Great versatility with this unit and so far it's working great. I had an old humidistat and thermometer and loved it, but you only have one option. Now you can use both or just temperature or humidity. Programming was a breeze and the machine feels more reliable than previous models. Works the way I need it. Probably worth the extra $30 over what this type of machine from Inkbird used to have. Recommended . I use one for salting meat and one for cheese.

Temperature controller works well, just use it as a heater at the moment. However, when I plug it in, the humidistat makes an awkward noise and says there is an error. I can't get to the settings, the only way I can turn it off is to unplug it from the network and when I plug it back in it just restarts the awkward sound. According to the manual, it is a short or an open circuit and once the fault is corrected it will continue to operate. I don't know what it means or how to fix it and there's…

They are very easy to set up. Setting the high/low/alarm temperature and humidity takes a few minutes, but once it's set you're done. Make sure you have enough power cords to safely access your devices. And then just get those suckers out of the way. They tend to be fairly accurate and the response time between temperature/humidity changes and reading changes is fast. I would recommend them for your garden, aquarium or animal habitat, they work great and take away a lot of plant/animal care…