🔦 IPCW CWC-7003 5.75" Plain Round Conversion Headlight with H4 Bulb - Single Piece Review

Glass warped and warped. Note the top of the bulb in the photos. The seller sent quickly. There are no problems with the sender, but the part is dangerous and of terrible quality. waiting for a return.

I also can't find how to contact the manufacturer without returning the goods. The items seem good but I bought them because they also had lightbulbs. There are no lightbulbs.

Didn't expect a flat lens. H4 bulb not included. Installation wasn't difficult, but I had to change the inner ring of my bucket to properly install the lamp. The glass is clear and appears to be of good quality. It came out cheaper than buying a NOS bulb for my GS 450.

No complaints - used them to replace the low beam on a 1960's Buick - fit perfectly. As lightbulbs I used a set of Aux Beam LEDs. Note that these do not have the necessary high beam cutouts. They are flat at the front, so they look a little different than a compression bar. Very important.

I bought 4 of these along with some LED headlight bulbs as I wanted to improve headlight performance in my '69 GTO. The lights are very bright and work very well for that matter. However, the quality control of these conversion lenses is terrible. The tabs on the back of the lenses that are supposed to index them properly in the headlights were *MUCH* disabled on some of the ones I got. On one of these, which had two tabs inserted into matching slots in the headlight, the 3rd tab missed the…

If I had time to wait for a regular headlight change, I would rather do it than use this "conversion kit". . Not enough warp on mine to cause problems or look unsightly, but still very disappointing. It's a little deeper than a standard sealed 5 3/4 beam and barely fits in my headlight bowl. There was no bulb included, if I hadn't opened the box before noticing that I would have screwed it up. The bike is my main mode of transport and I needed it badly as my headlight went out and I couldn't…