ISpring WGB32B PB Filtration Sediment Reducing Review

1. Revain processed the order about 5 days before it was shipped, when it finally shipped I received it the next day.2. A two-threaded fitting on the filter head was leaking, using plastic adapters they snug against the flange and wouldn't stop flowing, replaced them with zinc-plated shoulderless nipples and used a teflon pipe additive instead of duct tape and the block stopped flowing. Most importantly, even the nipples are fully seated within the body with no visible threads, which to me…

update: we still love it! We change the filters once a year! Everything is going great with our 3rd set. We have had this filter installed for about 5 months now and we love it. I have a family of five and we live in a house with five bathrooms, kitchen and bar. We have well water on our homestead and have installed a 1" Rusco/Vu-Flow 100 Mesh Spin Down Sediment Water Filter as instructed, to help with filter maintenance. I upgraded the filter cartridge in a 1" Rusco 200 mesh (74 micron) for…

We tested our water before purchasing it. We have found that our water is not so bad for well water. It has some hardness, sediment, and a little odor, but nothing harmful, more of an irritant. After doing some research on whole house filters, we found this system and decided to buy and install it. We couldn't be happier. The whole experience was easy. No leakage, no bad taste or smell. This system now feeds our entire house except for the outside faucets. My son came to visit after the…

This system is doing a great job filtering my well. PLAN to install in a location that may be humid. When changing filters, it's almost impossible to unscrew the filters without spilling some water on the wall and floor. Purchase and install a WSP pre-filter as it allows for easy pressure relief and significantly reduces water spillage. (I routed the plumbing outside, but draining into a 5 liter bucket or cooler will work even if there is now a drain.) Installing check valves and a bypass to…

I used a paste sealer as another reviewer suggested and it leaks even when using a lot of paste. I've used metal-to-metal paste with no problems, but metal-to-plastic leaks. I ended up using Blue Monster thread seal tape and wrapping the fitting 10 times (maybe more) and then running nails through the rungs to push them down a bit due to the amount of tape. Worked perfectly the first time. Did the same with the sump filter. Everything is based on 3/4 hookahs. Required Push Fit Parts: (2 no…

I'm on well water. The installation was about what I expected. I made sure the screws in the metal head holding the red buttons weren't loose. I attached the device directly to the wall, but I didn't like that it sags a bit (heavy). So I drilled a few holes in the metal frame and added the hooks, chains, and turnbuckles I bought at the hardware store. The turnbuckles allowed me to level the unit and support the weight evenly. I couldn't decide whether to use the Shark Bite fittings with…

This system is doing a great job filtering my well. PLAN to install in a location that may be humid. When changing filters, it's almost impossible to unscrew the filters without spilling some water on the wall and floor. Purchase and install a WSP pre-filter as it allows for easy pressure relief and significantly reduces water spillage. (I routed the lines outside, but dumping into a 5 liter bucket or cooler will work even if there is now a drain.) Installing isolation valves and a bypass to…

We hope this will help make everyone's life easier when looking for the right fitting. I used a paste sealer as another reviewer suggested and it leaks even when using a lot of paste. I've used metal-to-metal paste with no problems, but metal-to-plastic leaks. I ended up using Blue Monster Thread Seal Tape and wrapping the fitting 10 times (maybe more) and then running my nails through the steps to push them down a bit due to the amount of tape. Worked perfectly the first time. Did the same…