💯 Maximize Efficiency and Organization with the K-Edge Integrated Handlebar System Mount Review

When it's attached to my integrated handlebars, it's in the perfect position. My only minor complaint is that I wish I could tilt the GPS a little more at times when the sun's reflection is making it difficult to see the screen.

Strong bracket. Worked well with my Canyon Ultimate CP10 aerobars. Positions the headlight or camera farther back and almost under the mounting bolts, putting more stress on the mounting and rebound. After three other mounts, this is one.

Bought to install GPS and flashlight and so far so good! The only problem was that the mounting screws were wrong and this is clearly stated on the K-Edge website. However, the website told me what I needed from a hardware store to make it work - M4x20mm with 0.7 thread pitch. Now it's installed and working fine.

This was designed to use the Wahoo Roam on my new Canyon Grail:ON. It is well made and does exactly what it is intended for. Wahoo's position is straight. I like the fact that the plastic insert that interacts with the Roam should detach in the event of an impact. Hopefully this will save your computer from harm.

I thought it was a bit expensive at first until I got it. Compared to my previous one with no customization, I can definitely see the craftsmanship in the K-Edge. The bottom of my handlebars tilted my bike computer at an angle. The K adjustment allows the bike computer to be positioned horizontally to the handlebars. Also, the bottom bracket allows my light to be placed further. I should have bought this product the first time instead of wasting $20

I fitted this mount to my Canyon Grail with CP07 handlebars after visiting the hardware store to remove two M4 bolts to use - 0.7 x 16 mm and a pack of M4 washers. It was about an extra $2. After that, the mount went up easily and stayed in place throughout the bumpy gravel ride. Build quality seems good and I was willing to pay a little more since it's made in the USA. I have yet to use the bottom bracket, but I'll add light there.

Please note that this product failed on first use. I have a Garmin UT 800 flashlight and a Garmin 1030 computer attached above. It was attached to the handlebar through two holes at the very end as shown in the attached image. However, it broke after about 28 miles, luckily I always use a Garmin 1030 rubber strap to hold on to the handlebars. My first thought was to return it, but my bike tech was able to make it by drilling a hole and using other holes closer to the front of the item. Please…

This is a much needed product for mounting your Garmin/Wahoo/other (Hammerhead) bike computer to the handlebar which only has two screws on the bottom. The two screws that come with the K-Edge mount will NOT fit the Canyon CP07 Aero handlebar; You need thinner screws. It's annoying; Luckily I had thinner screws so this worked for me but you may have to go to your local hardware store. Another important part of this mount is the lantern holder; This mount effectively holds your computer and…

I fitted this mount to my Canyon Ultimate with CP10 cab and it looks and works well. I've searched the web for alternative solutions to install my Wahoo ELEMNT (original version) and haven't found anything that made me really happy, so I bought this one. If I'm picky I'd like them to tone down the branding on the side a bit as I felt it could distract from the look I was going for. I'm glad my computer basically hides the bracket below. I also wish the K-Edge had more screws and maybe some…