🔦 Enhanced SEO: KC HiLiTES 7316 Jeep Wrangler JK Windshield Hinge Light Mount Brackets (2007-2014) - Set of 2 Review

They look good says KC on the page I like them and they are easy to use. Not difficult at all. a good product. I'll update after I've had them for a while

I used these brackets to mount Apollo pro KC headlight. They fit perfectly and had a nice black finish. They also came with a rubber seal to protect the paintwork.

These brackets are easy to install. It only took a few minutes for each side. The brackets come with a thin piece of rubber that can be placed between the bracket and your Jeep to avoid scratching the paintwork.

Looked great for a few months. then they began to deteriorate. Now they look terrible. This is on a 2016 that has never been in the bush or off-road. I can't believe the poor quality of this painting

Very quick and easy install. Rubber discs and scratch protection protect the paint from scratches. Reliable product with which I have had no problems. Fits most light pods on the market. I use KC Apollo Pros and love the classic look.

These brackets have been on my Jeep for a little over a year and the paint is peeling and rust blisters under the paint. I had to remove, sand and repaint the brackets. The rubber seal is a joke too. When I removed the bracket, the "gasket" allowed water and debris to pool behind the bracket because the metal was not flat. The headlights are too close to the windshield making replacing the passenger side wiper blade @$$ a hassle.

Very satisfied with the KC a-Pilar mounts. Easy to install, they come with silicon washers and rubber pads to prevent scratching the paintwork. I read that this kit did not include gaskets but that is not the case. The mounts have a nice gloss black finish that will hopefully stand the test of time. My windshield is a bit messy in the corners, but that's not too bad. I have 6" slimlights but if I had 8" slimlights I would go elsewhere. Overall I'm satisfied and like the classic look.

I removed the hood panel (2008 Jeep Wrangler (JK) 2-door) and routed the wiring through (well sealed and neatly grouped) and installed switches on the cab . It looks fantastic and works fantastic. I made spacers out of real caulk that I bought from Advanced Auto to install between the brackets and mounting points due to the rust reviews I read on here. I only wear them for about a week but they are long lasting and I just don't see any problems. I can tell you that the design of these KC…