🔍 KHCRAFT Pro Indicator with Enhanced Hardened Components Review

My first clue was a squeaking noise as I used it to move the vise. My next clue was that the indicator was oscillating around 15,000 as it reversed direction. I have multiple import indicators and this is TOTALLY the worst. I don't trust him at all. I'm sure it will give accurate readings at a stationary point, but the probe tip has so much lateral play and no good mechanism to reduce it that the device is literally unusable. In fact, it has a benefit. This will remind me never to buy imported…

Update: After buying a good Mitutoyo dial gauge I became more confident in my measurements which led me to brought revise my review of KHKraft. So here it is: the dial needed a bit of work to get the display to zero smoothly (probably had some oil in it at some point too), the dial is pretty damn repeatable, but my problem was that I didn't understand the sensitivity level of these devices and probably my surfaces weren't clean enough and/or properly aligned. Experience is definitely key, I use

So I got this as a last resort after quitting a job supplying tools to another employer who was doing this didn't. In short, side by side with the bigger brands, it performs almost identically. Has served me well, but as I work for a living (machining) I will eventually switch to better known brands. Keep in mind that unless I had a direct comparison to peers' more expensive measuring tool, I probably would never trust it to do what I do. but it works and does the job I used to do to meet +/…