🔊 Enhance Your Sound System with KnuKonceptz Bassik 8 Gauge Complete Amplifier Installation Amp Wiring Kit with RCA Review

I received this package to fit a 300w small amp and 10" 300w RMS subwoofer in my 2007 Jeep Liberty. I've already swapped out the head unit and Infiniti speakers, but the bass was a bit lacking. This product helped me solve this problem. My installation has been running for about three weeks and I haven't had any problems so far. The length of the cables was more than enough for my setup and the kit comes with everything needed for installation. Aftermarket amplifier (not included) and subwoofer

I don't use a lot of CCA wire, but KnuKoncepts overstretch this product (stupid high strand count) and I've used it on a setup where a 4 gauge OFC would 'probably' suffice . Make sure you use a good quality grommet when going through the firewall unless going through a boot, and wrap them in duct tape to protect anywhere you think they might vibrate/rub could. The only reason I say this is because the strand count is so high that the insulation is thinner than their OFC products. I doubt it…

That's a great deal at $15. My amp is literally 20 inches below my main unit/under a cup holder on the floor. Not having to go that far left me with about half the blue battery wire (a true 8 gauge), probably 15 feet of extra RCA wire, and maybe that much of the little blue power wire. A HELPFUL HINT: The real dark brown wires from the amp to the subwoofer are the same color. So if you run the wires through the car it's impossible to tell which line is +/- unless you disconnect or tag them…

I bought another set that was 8 gauge and looked more like 14 gauge. I have a very expensive 8 gauge oxygen free copper wire of almost the same diameter. I used this for an inexpensive additional install and it worked great. RCA cables look cheap and I've decided not to use them and go with a better cable. But I was impressed with the connectors that came with it, as well as the wire, although it's not real copper wire. The wire was very soft and flexible for a copper clad aluminum wire…