🚲 KOM Cycling Tubeless Sealant Syringe with Presta Valve Core Removal Tool - Perfect for Stans No Tubes Sealant and Compatible with Other Brands Review

I used this through the valve stem syringe sealant injector and it worked pretty well. Very little clutter. I pumped 2 ounces from my Stan's gasket reservoir and opened the injector valve after inserting the thin hose that came with the kit through the valve stem with the valve removed and after you removed the hose/injector from the valve stem, twisted You can rock the wheel back and forth about 90 degrees and you're done. I hand inflated the tires again, checking for leaks and pressing on the

This injector is totally unusable. It will not work with Orange Seal or Panaracer SmartSeal. Particles that should clog the hole completely clog this tube and nothing can happen. Also, the hose is too narrow to actually go all the way to my valve stems, so it goes part way and then sprays sealant all over the wheel when it gets a fair bit before it gets clogged. I've attached a photo where you can see all the particles from the Panaracer SmartSeal that aren't getting through. Nothing went…

Tried a competitor's injector that screws onto the valve stem, what a pain to 'empty'! KOM Cycling is a rigid syringe-type plastic needle, after removing the valve core, it is inserted directly into the valve stem, pushes the piston down, you're done, reinsert the valve core, inflate the tire and you're on your way. To clean the syringe, remove the plunger, fill with warm water, depress the plunger, remove and separate the two-piece needle assembly, save all three components, the flexible…

After getting about 18 flats in two tires by going through a punctured vine, I decided to add some old-fashioned green slime to my fat bike chambers. Unfortunately, the inner chambers tend to have smaller Presta valves than the larger Schraeder valves. The green slime has tubes for Schrader valves but not for Presta. I went for this injector kit and was able to get the job done without any difficulty. The kit includes a small plastic key for removing Presta or Schraeder cores. The wrench has an

The easiest way to add sealant to a tire is to remove the valve core and inject the sealant into the tire with a syringe. Here's how it works: 1. Using a syringe, attach a long hose to the syringe and fill it with tire sealant.2. Remove the valve core using the valve core tool provided; I've personally used my parking valve tool, it's larger than the one that comes with it and easier to work with because it has more power.3. Put the syringe tube through the valve and inject the tire sealant.4…

KOM Cycling Tubeless Sealant is a great bike maintenance kit. If you use a tubeless setup on your bike, this sealant injector makes installation and maintenance easier and cleaner. Valve mount for 10" (250mm) total pipe length when you connect everything. This is important when pouring sealant from a large bottle and the liquid level is low. The hose will fit both Schrader and Presta valves, just be sure to remove the valve core. The kit I bought includes a red anodized aluminum valve core…