🛒 Kunhua 11-pu-y-dh-16p Flat Free Hand Truck/Utility Tire, 4.10/3.50-4", 2.25" Offset Hub, 5/8" Ball Bearings, 10" Diameter, Knobby Tread Review

We went to Tractor Supply and saw the prices for ribbed tires. I immediately went to Revain and found her. They were delivered on time and fit like a glove. I liked the ball bearings pressed into the wheel assembly. Drives very smooth and effortless. I would recommend checking them out. Costs money.

Mounted on a trailed chipper weighing approximately 200#. The bearings are sealed on the outside and appear to be of better quality than those that failed on the original tires. The Zerk fitting on the hub is too small for my grease gun so I replaced it with a standard one. I like that it's not pneumatic, there should be no more flats. Runs perfectly, hardly used.

Doesn't roll but I live in Las Vegas, Nevada and a lot of us have landscape rocks. The bike didn't move that well over rocks, it's just small rocks, but it was a hard push even on some turf and sand, it was hard to get through. I'm leaving, but I have a big job. I have to move a lot of rocks in my backyard so I may need to get an air tire, hope this helps

Complete Trash. They are valued at £300 each. I bought 4 for my welding cart. My cart weighs about 250 pounds. If the car is left idling for more than a few hours, flat spots will appear on the underside of the tires. The longer he sits, the flatter they become. I have to rock the cart with my foot to make it roll. Then as you pull the cart, knock, knock, knock every time the wheels turn. Eventually the flat spots will round out until I park it again.