👢 Optimized SB104 - Strut Boot by KYB Review

As far as I can tell this trunk and bumper is not compatible with the integrated bracket/bellows that comes with the Highlander C-pillars. However, I was able to glue the corrugated section of the new trunk to the bottom of the Toyota trunk after cutting off the torn section. It worked well pulling the trunk onto the rack case.

I've been a mechanic for almost 47 years and most of the reviews are from do-it-yourselfers. First, it will not improve driving performance. This is a fender and fender for your luggage rack. They are universal but have different part numbers for each car, front and rear. Use Rock Auto or KYB to verify part number, not Revain. The two parts are assembled so that the fender hangs on the fender. The chipper is tight against the shaft of the frame. Most of the jounce bumper fits inside the shield.

This item was for my car, then NOT and then again. I installed this part on a 2003 Altima shock. According to the manufacturer, it is for the front. Revane said they were for the back and then said they WILL NOT FIT MY CAR. Since I bought part numbers SB104 and SB108 I had to figure out where and how to install them. The bumper must be positioned with the wide part up, as in the Amazon image. The bellows/bellows must be placed on the edge of the shock absorber, it snaps into place. When…