🚦 LemonBest 4pcs 12V Universal Dual Color LED Motorcycle Turn Signal Blinker Lights for Yamaha Honda Suzuki Kawasaki Review

This is a fantastic deal! With three wires you can have front running lights as well as signals. I just connected the wires together so the front light flashes along with the turn signal. They look great and come with 16 gauge nipples so you can easily mount them for accidental disassembly. Simply a great product.

They're short and slender, but so dull they're practically useless during the day. The construction seems normal for the price. Clear lenses make them convenient on the bike. I don't know what those blue lights are, but they are there! My 4-piece set was missing a lens cap!

Simply built in, where the factory spaces are at the front, new spaces had to be drilled at the back, but that was to be expected. I received it on June 6th and at the end of August I noticed that my front right lamp was stuck on the wires. The black rubberized plastic came loose from the threaded mounting screw, although I was careful not to over-tighten it during installation. So I replaced them with another set I found and they are still holding up. Contacted seller 8 days ago but no sound…

Good turn signals, especially at a low price. However, they are not the most visible turn signals in sunlight. The first day I rode with them, someone started going straight when I made a left turn at a 4-way stop in front of them. Maybe it was another driver, but they're still not very visible. General. By price. It's pretty hard to beat. If other drivers (rarely) pay attention, everything is fine. It never hurts to use hand signals just to be sure!

Not very bright during the day. The headlights are poorly sealed, and the clear plastic lens quickly filled with dust from driving on dirt roads, and the dust then turned to dirt inside the lamp itself. If you get them you can put silicone on the joints to prevent this. Also, the wire gauge is very small, so you may have to cut the sheath further than you think and double it to make room for the wire terminations. Also keep in mind that the blue indicator on the back of each indicator is…

These are great little lights, elegant and relatively bright. There are complaints that they are plastic but oh well. You pay about $20 for them. Another frequently mentioned problem is the brightness during the day. This is partly because the circuit board that the LEDs are mounted on is white and therefore reflects light, making the yellow LEDs less noticeable. I removed the plastic covers and blackened the circuit board with a sharpie and now they are much more visible. It shouldn't be…

I bought these to replace the stock rear turn signals on my bike. The stems died and broke. I knew I needed to add some damping resistors since I was only replacing the rear signals. So while I was looking for a place to put the resistors I also made some wires that could be connected to the butt. connector, so I didn't cut my own wiring. I connected the wire from the blue running lights to the wire for the turn signals so both lights flash when a turn is selected. The backlight is quite…

OK. I know you get what you pay for and at 10.99 for four turn signals I wasn't expecting the cream of the crop. Although I expected something useful. Let me tell you about all the problems with these lights. Note that the description of the kits I bought said they would fit a 2002 Kawasaki Vulcan VN1500. You either have to lengthen the lines for these signals or, even better, connect them to the original wiring. I could live with that. I speak even better because. 2) The connectors used on…