🔧 LICHIFIT Replacement LIDAR Motor and Cable for Neato XV, Botvac 65, 70e, D80, D85 Robot Vacuum Review

Works perfectly. The manufacturer must have read the reviews as it comes with a cord extension that comes off the motor. Correctly connected.

The price was "normal" and it fixed my problem with the Neato Botvac 75 lidar (error 3000). Cables are factory wired. Once I swapped +/- it did its dirty work again.

This motor replaces the lidar motor. It comes with an extra cable/plug that reverses polarity so you don't have to swap it out on the motor when you receive it. This got my Botvac 80 working again.

Works great and easy to install. The original motor was connected with the positive wire to the negative wire and the new motor was connected with the positive wire to the positive terminal. You'll need to use the included adapter to extend the wire and correct polarity if you don't plan to solder it.

Although this device solved my problem, the network connection was MUCH short to be able to use it immediately. I had to take my soldering iron, remove the connection from the old and new motor and connect the connector from the old motor to the new one. I would have hoped this motor had at least the correct connector length out of the box, but changing the wires was easy enough.

This item is a direct replacement for the motor that powers the lidar system on my Botvac-80. Note that the wires are reversed where they are soldered to the motor BUT the motor wires have an extension so they are long enough to work in Botvac and the wires are reversed again where the extension was with the original ones lines is connected. So everything is fine. The motor has been running flawlessly for a few weeks now and I would buy another if needed, along with one of my other botvacs (I…

I saw some reviews that gave this product 4 stars because the connectors needed to be re-soldered or the cable wasn't long enough to install. In my specific case, I have a Botvac D80. The wires that were already on the block had to be removed and in the case of the D80 the red wire on the motor actually goes to negative. I think the best way to install this part is to remove the existing solder and then solder the factory wires in place. You still have to do it, so fixing your robot won't be…

Repaired my Neato Botvac D-Series (D80) perfectly! Once you've removed the old motor and its wire from the board, you can literally plug and play install this motor and then bolt everything back on (very easy!). My robot only lengthened about 1 foot before the repair. off the charger, makes all the normal cleaning noises and just sits down, then turns it off and beeps. No error messages, nothing squeaks. I went to YouTube: Neato Repair and found that my lidar tower wasn't spinning at all after…