💡 LightingWill 10pcs/Pack Strip Wire Solderless Snap Down 2Conductor LED Strip Connector for 10mm Wide 5050 5630 Single Color Flex LED Strips: Easy and Convenient Connection Solution Review

No need to say much, simple product, works as needed. Be sure to pay attention to positive and negative leads. The LEDs are polarity sensitive and will not work if reversed.

I think they would be great for putting led strips on my patio, cut lights as advertised where I plugged them in, it worked sometimes and other times , if I want the same color (and I've tried several times) SAVE YOUR MONEY

Used to terminate 24V DC LED strips that worked great for a few days. Then they all burned down. See pic. Brought them back thinking maybe a bad batch, same problem. I used them with a 24V DC 6AMP power supply. I haven't tried them with 12VDC, but if you're using a 24VDC load, keep scrolling.

They work well with 60 LED strips per meter but not with 120 LED strips per meter. The first LED in the row is too close to the pins for the clip to close. I ended up cutting off the lid clip and then taped the strip in place to ensure the connection was strong. This can be a bit finicky. Not an elegant solution, but it works and is still more reliable than trying to solder on pads.

I used these connectors on 10mm LED strips I used to convert fluorescent lights in my camper van. They're simple, fast, and work like a charm. I had no problems. The connections were positive on the first try. This is the best option for this type of project. No need to try soldering wires to these thin LED strips. Just FYI, I used the tip of a pocket knife to slightly pry open the connector tabs to make it easier to slide the end of the LED strip under the tabs. I also used a pocket knife to…