Header banner
Revain logoHome Page
lmt onsrud 67 212 phenolic uncoated logo

LMT Onsrud 67 212 Phenolic Uncoated Review

1

·

Average

Revainrating 3 out of 5  
Rating 
3.0
🪚 Router Bits, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(4)
img 1 attached to LMT Onsrud 67 212 Phenolic Uncoated
img 2 attached to LMT Onsrud 67 212 Phenolic Uncoated
img 3 attached to LMT Onsrud 67 212 Phenolic Uncoated
img 4 attached to LMT Onsrud 67 212 Phenolic Uncoated

Description of LMT Onsrud 67 212 Phenolic Uncoated

Solid carbide tools offer long tool life and faster cutting speeds than other substrates, but are more brittle and must be used with rigid toolholding systems. Uncoated tools feature just the base substrate without any additional treatment or coatings and are suitable for a wide range of applications. Round shanks allow use with a wide variety of toolholding systems. When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging. Three flute, 10 degree angle.

Reviews

Global ratings 1
  • 5
    0
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

I think you need to keep the RPM low or they will dull quicker

I cut phenol with this racquet and they don't last long. however, it might not be the bit's fault. I think you need to keep the RPM low or they will dull even faster. but I was fortunate to be able to cut for 1.5 hours before the bit dulled.

Pros
  • Three grooves, 10 degree angle
Cons
  • Packaging is ugly