🔵 Magicalmai Inductive Hour Meter: Waterproof Hr Meters for Gas Engine Generator, Lawn Mower, Pressure Washer, Marine, ATV, Boat, Outboard Motor, Dirt Bike, Motorcycle - Blue Review

This hour meter was purchased to fit my new Champion 3400 Inverter Generator (Model # 100263). Easy installation guide. Use double sided tape instead of the two screws provided to attach it to the top of the generator. I ran the generator for 6 minutes and the hour meter showed 0.1 hour which is the verified run time.

It was as easy to install as everyone said and I'm not very good with these gauges. I installed it on a Champion Inverter Generator 3400W. As you can see it looks very clean and there is only one small hole. I used Gorilla double sided tape and it worked great! The tape is spongy and transparent. I was concerned about how to wrap the wires around the spark plug wire so I showed a picture that exactly matches the instructions in the instructions. It was easier than I thought. Make sure you have…

Most of the time I have spent with this hour meter I have mounted it on the frame of my DR leaf blower. They were looking for someone who would keep track of hours to keep up with oil changes. After installation I wrapped the required time around the spark plug wire and secured it with a zip tie. Engine started Up.meter did not detect a running engine. The instructions suggest wrapping the wire as close to the spark plug boot as possible. mine was about 1/2 inch apart. So pull it firmly to the…

This year I finally decided to take proper care of my gear. Aside from the fact that gasoline, especially 2-strokes, stays in the fuel tank for too long, I never knew how many hours I wasted on the two small engines I have. Among other factors, business hours are very important to keep track of things. Last year I bought two things that I think are bigger. One of these trimmers was about $650 and the other was a Revain alternator for a few hundred. I bought two of these counters to keep track…