🔥 MagnaFlow 10785 Performance Exhaust Pipe Review

I specifically ordered Magnaflow thinking it would be a quality product but upon receipt of the part the welds were of poor quality and the cutout was not even soldered together. Not at all what I expected.

Magnaflow looks nothing like the one for sale. Magnaflow looks like Joe silencers, regular rough unpolished junk. Got2go63@yahoo.com PLEASE contact me, I will do my best to tell your customers how you are misleading them.

Flange bolt holes are 3 3/4" and all threads here are 3 3/8" so they won't work together leaving you stuck with wing nuts and bolts that you can give and remove when you want to open the exhaust.Electric blades have slots from 3 3/8" to 3 3/4" holes so they fit a variety of sizes.

It could be better to remove the burrs. Note that the bolt size for the flange is actually 3.5" even though a 3" pipe is used. This is to get rid of the wide, flat flare at the end of the tube (which was actually slightly bent). So if you plan to use something like the 3 inch QTP rotator you will need to cut out the screw holes and deepen the flare a bit. quality piece.

I specifically ordered Magnaflow thinking it would be a quality product but when I received the part the welds turned out to be of poor quality and the cutout would not let up weld once . Not at all what I expected.

Magnaflow does not look like the one for sale. Magnaflow looks like Joe silencers, regular rough unpolished junk. Got2go63@yahoo.com PLEASE contact me, I will do my best to tell your customers how you are misleading them.

Save money don't buy this poorly designed product. The product does not cost $70 and certainly does not match the quality of the picture. In my case it would be a flow restriction. Spoke to Magnaflow, they didn't seem interested in the quality of their products when I asked for a device with an improved design.

Deburring could have been better. Note that the bolt size for the flange is actually 3.5" even though a 3" pipe is used. This is to get rid of the wide, flat flare at the end of the tube (which was actually slightly bent). So if you're planning on using something like a 3" QTP rotator, you'll need to drill holes for the screws and deepen the flare a bit. quality piece.