🐠 Malida Water Filter Set: 1/4" Float Ball Valve, Connector 4 Pcs, 5m Tubing - Ideal for Fish Aquarium, 1/4 Inch Supply Wall Installation Review

Used as fill in a 55 gallon polyethylene drum for a fertigation system. a fairly small unit with a 1/4" lead (included). The block sticks out about 4" but has a metal valve lever. It seems stronger than those plastic lever blocks. Installed about two weeks ago and works fine .

Purchased to be installed at the end of a vertical bath going through the lid of a reverse osmosis water tank. I quickly found that it should only work when the inlet pipe was horizontal. So if you have such situation, this could be a good product for you. It's inexpensive and comes with a variety of parts and pipes.

I ordered 4 of these float valves at a time. Half were packaged differently, some connectors and hoses were missing. Although the package numbers were the same. The bags were clearly too small to ever have a tube in them so this is obviously a supplier issue. I was told to back order but what am I actually getting? The floats actually work and appear to be of good quality. The complete packages are great. Mysterious packages, not so much. i need two more I think I'll order more and see what I…

This is the smallest float I've ever seen, but this little guy hops around in circles around his larger counterpart. It is very easy to install and comes with two connector sizes. 1/4" to 1/4" elbow and 1/4" to 1/2" elbow, both connectors are included. Make a 1/2 inch hole in the side of your tank, insert this little guy, tighten the screw with your hand, press on your knee to connect the hose and you're done. The system turns off after filling. I put some tape on it. Thread to ensure there are